View Single Post
  #4  
Old 01-12-2020, 06:35 AM
hairba11's Avatar
hairba11 hairba11 is offline
Rollin' in the winnie
 
Join Date: Sep 2008
Location: St. Louis (high ridge)
Posts: 2,606
Member Number: 4269
B/S/T Feedback: (26)
Default



The next step was working on lights and winch.
I bent up a piece of aluminum to fit inside the rear body mount. I took a DPDT switch and ground the tip of the toggle flat, then drilled and tapped it M3. A little shorty link connected to a servo gave me the winch controller on ch5

Then I mounted the micro servo Y’d to the throttle in the middle and put snap switches on either side. One runs the reverse lights off the NO position, and the other runs the brake lights off the NC position.

Two remote control switches turn the van running/head lights on and off with ch4 and the off-road lights on and off with ch6




Sent from my iPhone using Tapatalk
__________________
This forum requires that you wait 30 seconds between searches. Please try again in 18 seconds.
Reply With Quote